Unit · AXIAL-PISTON PUMP
AA10VO85EP2D/53L-VUC61N00P-S5186R902506585
Axial piston pump Bosch Rexroth series A10VO, type code AA10VO85EP2D/53L-VUC61N00P-S5186, material number R902506585. Nominal size: NG 85. Axial piston unit: swashplate design, variable, nominal pressure 250 bar (3600 psi), maximum pressure 315 bar (4550 psi) (A10V). Operating mode: pump, open circuit (O). Control device: with pressure control U = 24 V (EP2D). Direction of rotation: viewed on drive shaft counter-clockwise (L). Sealing material: FKM (fluorocarbon rubber) (V). Drive shaft: reduced diameter, limited suitability for through drive (U). Mounting flange: based on ISO 3019-1 (SAE) 2-hole (C). Working port: SAE flange ports fastening thread UNC not for through drive according to ISO 6162 rear UNC (61). Through drive: without through drive (N00). Connector for solenoids: DEUTSCH – molded connector, 2-pin – without suppressor diode (for electric controls) (P). Special version no. 5186.
- Number
- R902506585
- Type code
- AA10VO85EP2D/53L-VUC61N00P-S5186
- Group
- A10VO 85
- Edition
- 06/2020
This parts list has no drawing.
| Pos. | Number | Name | Qty | Add to inquiry |
|---|---|---|---|---|
| 1 | R902506701 | BASE UNIT Assembly parts list →L | 1 | |
| 2 | R902477025 | CONTROL VALVE Assembly parts list →L | 1 | |
| 3 | R902439082 | CONTROL VALVE Assembly parts list →L | 1 | |
| 4 | R902438534 | ADJUSTING PIECE Assembly parts list →L | 1 | |
| 30 | R910967351 | SCREW PLUG | 2 | |
| 40 | R902429967 | STOP SCREW | 1 | |
| 43 | R910919314 | O-RING | 1 |
Parameters from the type code
| Item | Meaning | Code |
|---|---|---|
| Axial piston unit | Swashplate design, variable, nominal pressure 250 bar (3600 psi), maximum pressure 315 bar (4550 psi) | A10V |
| Operating mode | Pump, open circuit | O |
| Size (NG) | 85 | 85 |
| Control device | with pressure control U = 24 V | EP2D |
| Series | Series 5, index 3 | 53 |
| Direction of rotation | Viewed on drive shaft counter-clockwise | L |
| Sealing material | FKM (fluorocarbon rubber) | V |
| Drive shaft | reduced diameter, limited suitability for through drive | U |
| Mounting flange | Based on ISO 3019-1 (SAE) 2-hole | C |
| Working port | SAE flange ports fastening thread UNC not for through drive according to ISO 6162 rear UNC | 61 |
| Through drive | Without through drive | N00 |
| Connector for solenoids | DEUTSCH – molded connector, 2-pin – without suppressor diode (for electric controls) | P |