Unit · AXIAL-PISTON PUMP
A A10VNO85EK1DS/53R-VWC11N00P-S4772*PT*R902549002
Axial piston pump Bosch Rexroth series A10VNO, type code AA10VNO85EK1DS/53R-VWC11N00P-S4772*PT*, material number R902549002. Nominal size: NG 85. Axial piston unit: swashplate design, variable, nominal pressure 210 bar (3050 psi), maximum pressure 250 bar (3600 psi) (A10VN). Operating mode: pump, open circuit (O). Control device: pressure and flow control with U = 12 V controller cut-off (load sensing) X-T plugged (EK1DS). Direction of rotation: viewed on drive shaft clockwise (R). Sealing material: FKM (fluorocarbon rubber) (V). Mounting flange: based on ISO 3019-1 (SAE) 2-hole (C). Working port: according to ISO 6162 rear not for through drive (11). Through drive: without through drive (N00). Connector for solenoids: DEUTSCH – molded connector, 2-pin – without suppressor diode (for electric controls) (P).
- Number
- R902549002
- Type code
- A A10VNO85EK1DS/53R-VWC11N00P-S4772*PT*
- Group
- A10VNO 85
- Edition
- 06/2020
This parts list has no drawing.
| Pos. | Number | Name | Qty | Add to inquiry |
|---|---|---|---|---|
| 1 | R902549258 | BASE UNIT Assembly parts list →L | 1 | |
| 2 | R902452299 | CONTROL VALVE Assembly parts list →L | 1 | |
| 3 | R902438427 | CONTROL VALVE Assembly parts list →L | 1 | |
| 4 | R902530992 | ADJUSTING PIECE Assembly parts list →L | 1 | |
| 5 | R902515765 | SWIVEL ANGLE SENSOR Assembly parts list →L | 1 | |
| 30 | R910967343 | SCREW PLUG | 2 |
Parameters from the type code
| Item | Meaning | Code |
|---|---|---|
| Axial piston unit | Swashplate design, variable, nominal pressure 210 bar (3050 psi), maximum pressure 250 bar (3600 psi) | A10VN |
| Operating mode | Pump, open circuit | O |
| Size (NG) | 85 | 85 |
| Control device | pressure and flow control with U = 12 V controller cut-off (load sensing) X-T plugged | EK1DS |
| Series | Series 5, index 3 | 53 |
| Direction of rotation | Viewed on drive shaft clockwise | R |
| Sealing material | FKM (fluorocarbon rubber) | V |
| Mounting flange | Based on ISO 3019-1 (SAE) 2-hole | C |
| Working port | according to ISO 6162 rear not for through drive | 11 |
| Through drive | Without through drive | N00 |
| Connector for solenoids | DEUTSCH – molded connector, 2-pin – without suppressor diode (for electric controls) | P |