Unit · AXIAL-PISTON PUMP
AL A10V O 45EP1DS/53R-VUC64N00P -SO928R902557069
Axial piston pump Bosch Rexroth series A10VO, type code ALA10VO45EP1DS/53R-VUC64N00P-SO928, material number R902557069. Nominal size: NG 45. Axial piston unit: swashplate design, variable, nominal pressure 250 bar (3600 psi), maximum pressure 315 bar (4550 psi) (A10V). Operating mode: pump, open circuit (O). Control device: with pressure and flow control U = 12 V (load-sensing) X-T plugged (EP1DS). Direction of rotation: viewed on drive shaft clockwise (R). Sealing material: FKM (fluorocarbon rubber) (V). Drive shaft: reduced diameter, limited suitability for through drive (U). Mounting flange: based on ISO 3019-1 (SAE) 2-hole (C). Working port: threaded port, UNC rear not for through drive (64). Through drive: without through drive (N00). Connector for solenoids: DEUTSCH – molded connector, 2-pin – without suppressor diode (for electric controls) (P). Special version no. 928.
- Number
- R902557069
- Type code
- AL A10V O 45EP1DS/53R-VUC64N00P -SO928
- Group
- A10VO 45
- Edition
- 06/2020
This parts list has no drawing.
| Pos. | Number | Name | Qty | Add to inquiry |
|---|---|---|---|---|
| 1 | R902467746 | BASE UNIT Assembly parts list →L | 1 | |
| 2 | R902450439 | CONTROL VALVE Assembly parts list →L | 1 | |
| 3 | R902439081 | CONTROL VALVE Assembly parts list →L | 1 | |
| 4 | R902438539 | ADJUSTING PIECE Assembly parts list →L | 1 | |
| 30 | R910967343 | SCREW PLUG | 2 | |
| 40 | R910947854 | STOP SCREW | 1 | |
| 41 | R910998240 | NUT | 1 | |
| 42 | R910961839 | CAP NUT | 1 | |
| 43 | R910804886 | O-RING | 2 |
Parameters from the type code
| Item | Meaning | Code |
|---|---|---|
| Axial piston unit | Swashplate design, variable, nominal pressure 250 bar (3600 psi), maximum pressure 315 bar (4550 psi) | A10V |
| Operating mode | Pump, open circuit | O |
| Size (NG) | 45 | 45 |
| Control device | with pressure and flow control U = 12 V (load-sensing) X-T plugged | EP1DS |
| Series | Series 5, index 3 | 53 |
| Direction of rotation | Viewed on drive shaft clockwise | R |
| Sealing material | FKM (fluorocarbon rubber) | V |
| Drive shaft | reduced diameter, limited suitability for through drive | U |
| Mounting flange | Based on ISO 3019-1 (SAE) 2-hole | C |
| Working port | Threaded port, UNC rear not for through drive | 64 |
| Through drive | Without through drive | N00 |
| Connector for solenoids | DEUTSCH – molded connector, 2-pin – without suppressor diode (for electric controls) | P |